Kramer Electronics VP-771 - Manual (Page 53)

48 VP-771 - The Display Modes
7.2.3 Selecting the PIP Source
To select a PiP source you have to set the VP-771 to any of the PiP display mode
configurations and then select the desired input.
7.2.3.1 Selecting the PiP Source via the Front Panel Buttons
Press and hold the PIP front panel button while pressing the input button of the
required PiP source.
For example, to select CV 1 as the PiP source over DP as the main source, press
the PIP front panel button while pressing the CV 1 front panel button (see Figure
30 ).
In this example, the DP button is illuminated and the CV 1 button blinks
Figure 30: CV1 superimposed over DP
7.2.3.2 Selecting the PiP Source via the IR Remote Control Transmitter
Press the PIP button on the IR transmitter (the PIP front panel button is
illuminated). Press the desired PiP source button on the IR transmitter (see
Section
8.5
).
7.2.3.3 Selecting the PiP Source via the REMOTE Terminal Block Connector
See Section 8.4 .