Kramer Electronics VS-88V - Manual (Page 12)

Your Matrix Switchers
9
Table 2: VS-88V 8x8 Video Matrix Switcher Features
# Feature Function
1 POWER Switch Illuminated switch supplying power to the unit
2 ALL Button (ALL= All Outputs) Pressing ALL before pressing an INPUT button, connects that input
to all outputs 1
3 OFF Button (OFF= All Inputs) Pressing OFF after pressing an OUTPUT button disconnects that
output from the inputs. To turn off the connections, press the ALL
button and then the OFF button
4 SELECT OUT Buttons Selects the output to which the input is switched (from 1 to 8)
5 SELECT IN Buttons Selects the input to switch to the output (from 1 to 8)
6 STO Button Pressing STO (STORE) followed by an output button stores the
current setting (see section 7.3.1) 2
7 RCL Button Pressing the RCL (Recall) button and the corresponding OUT key
recalls a setup. Press the RCL button again to implement the new
status (see section 7.3.2)
8 IN SYSTEM Button Pressing IN SYSTEM twice 3 , switches between the Standalone
mode (in which the switcher implements any action independently
from the others) and the In System mode (in which all switchers
implement the same action simultaneously)
9 TAKE Button
(TAKE = CONFIRM)
Pressing TAKE toggles the mode between the CONFIRM mode 4
and the AT ONCE mode (user confirmation per action is
unnecessary)
10 OUTPUT labels Identifies a connection between the output and the input shown
below it
11 INPUT Status Display Displays the selected input switched to the output (marked above
each input)
12 Input Status LEDs Illuminates when the input signal is presented on a corresponding
line and complies with the SDI standard
13 INPUTS BNC Connectors Connects to the video sources (from 1 to 8)
14 OUTPUTS BNC Connectors Connects to the video outputs (from 1 to 8)
15 SYNC BNC Connectors For looping to external video sync input
16 75 ohms Button Controls loop termination 5
17 RS-232 IN 9-pin D-sub Connector Connects to PC
18 MACHINE # DIP-switches For setup of the machine number (see section 7.2.1)
19 RS-485 Connector RS-485 detachable terminal block port. Pins # 1 to # 3 are for RS-
485 and pin # 4 is for vertical sync distribution 6
20 RS-232 OUT 9-pin D-sub
Connector
Connects to the RS-232 IN 9-pin D-sub port of the next unit in the
daisy-chain connection 7
21 Power Connector with Fuse AC connector enabling power supply to the unit
1 For example, press ALL and then Input button # 2 to connect input # 2 to all the outputs
2 For example, press STO and then the Output button # 3 to store in Setup # 3
3 After pressing IN SYSTEM once, it blinks
4 When in Confirm mode, the TAKE button illuminates
5 Push in to terminate the SYNC line. Push out when the line extends to another unit
6 The 88 Series RS-485 connector has 4 pins
7 If the unit is the final unit in the daisy-chain connection, no termination is required