Kramer Electronics VS-88HD - Manual (Page 14)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating the VS-88HD
12
7 Operating the VS-88HD
You can operate your VS-88HD via the front panel buttons, and/or
RS-232/RS-485 serial commands transmitted by a PC, touch screen system,
or other serial controller.
7.1 Switching OUT-IN Combinations
To switch an input to an output via the front panel buttons, in the AT ONCE
mode (see section 7.2), do the following:
1. Press an OUT SELECT button 1 or the ALL button.
The input under the selected output on the 7-segment display blinks.
2. Press an IN SELECT button 1 or the OFF button 2 .
The selected input switches to the selected output.
The digits displayed in the 7-segment display change appropriately.
7.2 Confirming Settings
Choose to work in the AT ONCE or the CONFIRM mode. When the
VS-88HD operates in the AT ONCE mode, pressing an OUT-IN combination
implements the switch immediately. In the CONFIRM mode, the TAKE
button must be pressed to authorize the switch.
In the AT ONCE mode, you save time as execution is immediate and actions
require no user confirmation. However, no protection is offered against
changing an action in error.
In the CONFIRM mode:
You can key-in several actions and then confirm them by pressing the
“TAKE” button, to simultaneously activate the multiple switches
Every action requires user confirmation, protecting against erroneous
switching
Execution is delayed until the user confirms the action
1 From 1 to 8
2 For deselecting the input