Kramer Electronics EDID Designer - Manual (Page 13)

EDID Designer - Using the EDID Designer 11
4.2 Connecting to a Device
Connect to a Kramer device (for example, a matrix switcher) to view, edit and copy
its EDIDs. The list of supported Kramer devices updates each time you launch the
software and your PC is connected to the Internet.
Note: When a new version of EDID Designer is available for installation, a new
version notification appears upon launch.
Important: When your Kramer device supports both Protocol 2000 and Protocol
3000 communication protocols, make sure it is set to Protocol 3000 mode.
To connect a device:
1. Choose the connection method by clicking gear icon on the Connect button.
The parameter window opens.
2. For Ethernet, enter the correct IP address and port number.
3. For Serial, check the desired port(s).
4. Click the Apply button to save the changes.
Note: For serial connections, after pressing the Connect button, EDID
Designer scans all the checked ports and connects to the first one that
responds with an active device. If multiple devices are connected, check only
the port of the desired device.