Kramer Electronics SP-10D - Manual (Page 15)

Operating the SP-10D Digital Video Processor
13
6. Press the STORE button once.
For 5 seconds no output video signal is available, and “rL” is displayed in
the 7-segment display, indicating that the SP-10D is reloading.
After the reloading, the standard of the output video signal changes as well
as that of the “Before/after” split-screen.
7. Press the GENLOCK button to enable the genlock function.
If the SYNC BNC connector
1
is connected to a genlock source, and the
standard of the signal on this input coincides with the standard of the output
video signal, the GENLOCK button illuminates. If not, the GENLOCK
button flashes.
8. Adjust the color
2
, brightness, contrast, hue, sharpness
3
, H-shift, V-shift
4
,
(Delay, SCH if required for genlock) and/or the video gain of the picture, as
follows:
• Press the appropriate button 5
The button illuminates, and flashes, and the 7-segment display
shows the current level (in digits)
The digit “0” corresponds to the normal level (“NORM”)
• Press the + button or – button once to gradually increase or
decrease the current level by one unit (the 7-segment display
shows the new level).
To increase or decrease the current level rapidly, press and
hold down the + button or – button, continuously
6
. To end the
rapid adjustment, release the + button or – button
Note, if you want to:
• Set the normal level (“NORM”) of the current level, press and
simultaneously hold down both the + button and – button.
The 7-segment display shows “0”
• Undo the adjustment, press the appropriate button one more
time. The appropriate button no longer flashes
• Save the result of the adjustment, press the STORE button
twice
1 Item 50 in Table 2
2 The SP-10D has a full range of color control features in both YUV and RGB color spaces with independent control of RED,
GREEN and BLUE; and Y, R-Y and B-Y
3 Using the V-SHARP and H-SHARP buttons
4 Using the V-SHIFT and H-SHIFT buttons
5 See the relevant items defined in Table 1
6 The 7-segment display starts to quickly scan the range. When it stops running, it has reached the maximum or minimum
setting