Kramer Electronics TP-45EDID - Manual (Page 12)

TP-45EDID - Connecting a Component/XGA – Audio Distribution System 9
5 Connecting a Component/XGA – Audio
Distribution System
The Component/XGA – Audio Distribution System can be configured to operate in
one of two video modes:
•
In the XGA mode, a computer graphics source is connected to the input and
transmitted to a display connected to the receiver (see Section 5.1 )
•
In the component video mode, a component video source is connected to
the input and transmitted to a TV set connected to the receiver (see Section
5.2 )
The Component/XGA – Audio Distribution System can be configured to operate in
one of two audio modes:
•
In the analog mode, an analog audio source is connected to the input and
transmitted to an acceptor connected to the receiver (see Section 5.1 )
•
In the digital audio mode, an S/PDIF audio source is connected to the input
and transmitted to a digital acceptor connected to the receiver (see Section
5.2 )
Thus, there are four possible system configurations: computer graphics/analog
audio, computer graphics/digital audio, component video/analog audio, and
component video/digital audio.
The modes of the system are determined by setting the VIDEO SELECT and
AUDIO SELECT switches on the TP-45EDID. Whatever modes are set at the
transmitter the video and audio signals are sent to the receiver and any additional
cascaded receivers.
There is no signal conversion; a component input cannot be sent to a computer graphics
output, nor can a digital audio input be sent to an analog audio output.