Kramer Electronics TP-45EDID - Manual (Page 18)

TP-45EDID - Acquiring the EDID 15
6 Acquiring the EDID
The transmitter can acquire the EDID information from the display connected to
the transmitter or acquire the default EDID.
To acquire the display EDID, do the following:
1. Connect the XGA INPUT 15-pin HD connector to the input XGA connector of
the display, using a short cable.
The EDID is carried over pins 12 and 15 of the VGA connector. It is essential that the
cable used for capturing the EDID passes all 15 pins
2. Connect power to the display.
3. On the transmitter, connect the 12V DC power adapter to the power socket
and connect the adapter to the mains electricity.
4. Press the EDID CAPTURE button.
5. Once the EDID STATUS LED flashes slowly several times, the EDID is
captured.
6. Disconnect the display.
To acquire the default EDID:
Do not connect the display to the transmitter when acquiring the default EDID.
1. On the transmitter, connect the 12V DC power adapter to the power socket
and connect the adapter to the mains electricity.
2. Press the EDID CAPTURE button.
3. Once the EDID STATUS flashes rapidly several times, the default EDID is
captured.
Alternatively, you can press the EDID CAPTURE button after connecting the
transmitter receiver system. When the EDID STATUS LED flashes rapidly several
times, the default EDID information is acquired.