M&G DuraVent DuraTech® Canada - Manual (Page 13)

13
SPECIALIZED COMPONENTS 
ANCHOR PLATE (DTC-AP)
INSULATED WALL RADIATION SHIELDS
This support is used on a masonry fireplace
or on top of a furnace to provide a positive
connection to the chimney. It is not to
be used in contact with any combustible
material, such as on a wood floor.
INSTALLATION INSTRUCTIONS
Once the appliance is installed, bolt the anchor plate to it. Install the
chimney according to the installation instructions for the finish support
(DTC-FSC).
FACTORY-BUILT FIREPLACES
For chimneys installed on factory-built fireplaces, follow the installation
instructions accompanying the fireplace.
INSULATED RADIATION SHIELD (DTC-FSI)
It must be used in combination with an attic radiation shield (DTC-ISI)
when passing through an attic. This component provides a 2"-safety
clearance to combustible materials surrounding the chimney.
ANGLED INSULATED RADIATION SHIELD
(DTC-WRSI30/DTC-WRSI45)
It has been designed for use when a chimney passes through a wall at
an angle. (See figure 27 for application).
Ø
INT.
FRAMING SIZE
DTC-FSI DTC-WRSI30 DTC-WRSI45
7’’ 8’’ 10’’ 7’’ 8’’ 10’’ 7’’ 8’’ 10’’
A 16 16 18 37-3/4 39-3/4 45-5/16 26-5/8 28 30-1/2
B 3 3 3 16-5/8 17-5/8 19-3/8 16-5/8 17-5/8 19-3/8
C 13 13 5 12-5/8 13-5/8 15-3/8 12-1/8 13-1/2 14-7/8
D -- -- -- 33-3/4 35-3/4 39-1/4 22-1/8 23-1/2 26
E -- -- -- 3 3 3 3 3 3
Table 11
DTC-AP
Figure 25
Figure 26
A
B
C
DTC-FSI
DTC-WRSI30
DTC-WRSI45
A
D
B
C
E