Travis ZC Kit – Large Pellet - Manual (Page 8)

ZC Kit – Large Pellet Insert
(99200149)
Page 8 of 8 10/9/06 © Travis Industries, Inc.
Insert Preparation and Placement
•
Place the extending hopper into its highest position (see the manual for details). This increases the pellet
capacity of the heater.
•
Install the surround panels onto the insert and slide it into place. The surround panels must maintain a
3/8” gap from the enclosure opening (the stand-offs on the surround panels provide the 3/8” spacing).
•
After the insert is in place, attach the vent starter section to the insert (it is attached with a latch – make
sure the gasket is correctly positioned).
•
The leveling bolts may be used to level the insert.
•
We recommend the use of the Insert Wiring Kit when installing this kit (SKU 97200315). This kit allows
for the power cord to be hard-wired behind the walls, eliminating the need for a visible power cord.
Wall Thimble (note 3” clearance between
vent and combustibles)
12”
Minimum
Enclosure Height
(measure from top of
floor protection)
House Shield
(prevents soot discoloration)
HIGHLY RECOMMENDED
Floor Protection
Rear Vent Shield (used only on inserts
venting directly to the rear - note how it is
slid back until it contacts the wall thimble)
Vent Latch (used to connect and
disconnect the vent )
Vent Clearances (make sure
all vent maintains 3” clearance
to any combustible)
Outside Air
Connection
(recommended)