Alliance Laundry Systems FLW1527C - Manual (Page 11)

Installation
9 803447 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Risers
Risers (or air cushions) may have to be installed if the
pipes knock or pound when flow of water stops. The
risers are more efficient when installed as close as
possible to the water supply faucets (refer to
Figure 6).
Figure 6
Step 3: Connect Drain Hose to Drain
Receptacle
Remove the drain hose from its shipping position on
the rear of the washer by removing the shipping tape.
IMPORTANT: Drain receptacle must be capable of
handling a minimum of 3.5 cm (1-3/8 inch) outside
diameter drain hose.
Figure 7
Standpipe Installation
Place the drain hose into the standpipe.
Remove the beaded tie-down strap from accessories
bag and place around standpipe and drain hose and
tighten strap to hold hose to standpipe. Refer to
Figure 8. This will prevent the drain hose from
dislodging from drain receptacle during use.
Figure 8
W005I
1 Risers (Air Cushions)
2 Water Supply Faucets
W005I
2
1
FLW1982N
1 Shipping Tape
FLW1983N
1 Standpipe 5.08 cm (2 in.) or 4 cm (1-1/2 in.)
1
FLW1983N
1
61 TO 91.44 cm
(24 TO 36 in.)
RECOMMENDED
HEIGHT