Alliance Laundry Systems FLW1527C - Manual (Page 13)

Installation
11 803447 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Step 5: Remove the Shock Sleeves and
Shipping Brace
Remove front access panel by removing the two screws
at the bottom of the panel.
Remove the five bolts and lockwashers from shipping
brace with a wrench and remove brace. Refer to
Figure 10. Four bolts are located on the washer base
and one is holding the brace to the weight. Remove all
four shock sleeves by pulling on the yellow rope.
Remove label from front side of front access panel and
place on backside of front access panel for future
reference.
NOTE: The shipping brace, bolts, washers and
shock sleeves should be saved and MUST be
reinstalled whenever the washer is moved more
than 1.22 m (4 feet). Refer to User-Maintenance
section for instructions. Do not lift or transport
washer from front or without shipping materials
installed.
Store the shipping materials in the bag provided in the
accessories bag. Save materials for use whenever the
washer is moved.
Reinstall front access panel.
IMPORTANT: DO NOT tip washer more than
152.4 mm (6 inches) in any direction after shipping
brace has been removed. Shock absorbers may
separate and damage to washer may result. For
leveling purposes, the washer may be tilted a
maximum of 152.4 mm (6 inches) in any direction.
Figure 10
Step 6: Wipe Out Inside of Wash Drum
Before using washer for the first time, use an all-purpose
cleaner, or a detergent and water solution, and a damp
cloth to remove shipping dust from inside wash drum.
Figure 11
FLW2124N
1 Shock Sleeves
2 Motor Mount
3 Hooked End of Shipping Brace
4 Bolts and Lockwashers
FLW2124N
2
1
4
3
FLW2135N
FLW2135N