American Aimers B4A - Manual (Page 10)

B4A manual page 10 Page 1 of 1
http://www.hopkinsmfg.com/test2/b4a_manual_page_10.htm 8/13/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
B4A Instruction Manual
Page 10
4. To adjust the rods to the required position, turn the rods to the neutral position (Fig. 15) and slide in or out to
the proper setting.
Then turn the rod clockwise to lock in an odd number (Fig. 16) and counter-clockwise to lock in an even number
(Fig. 17).
5. Place the aimers with the adaptors onto the headlamps. If the adjustment rods do not touch the aiming pads,
use the extension studs to provide proper reach for the vacuum cup, or remove one or both of the extension
studs (Fig. 18). If the articulating vacuum cap does not touch the lens of the headlamps, then add one or both of
the extension studs to the vacuum cup assembly (Fig. 19).
Return to table of contents
[ Home ] [ Vision ] [ LiteMate ] [ Levels ] [ Contact Info ]