American Aimers B4A - Manual (Page 5)

B4A manual page 5 Page 1 of 1
http://www.hopkinsmfg.com/test2/b4a_manual_page_5.htm 8/13/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
B4A Instruction Manual
Page 5
FIGURE 5 (CONT'D)
Rectangular systems - use adjustable black adaptors for some
aiming pad locations.
FIGURE 6
Mini-quad headlamp systems - use 90 x 150mm adaptors.
The mini-quad headlamps are so small there is no room for the pads on the lens surface. Therefore, the pads
are located on the sealing flange around the lens. The adaptor rests on the retainer - aiming ring which covers
the aiming pads.
FIGURE 7
2. Steel inserts are molded into position in all adaptor except the 90 x 150mm mini-quad adaptor (See Fig. 7) to
ensure accuracy. These inserts must be in contact with three aiming pads on the lamps when the aimer is
properly positioned (Fig. 6).
Return to table of contents
[ Home ] [ Vision ] [ LiteMate ] [ Levels ] [ Contact Info ]