CPI Communications TTP216 Series - Manual (Page 10)

Example2: Un-Assign A Discrete Split Output from Its EIA Tone
After loading Pre-Set #5:
a. Turn the Y switch ON.
b. Turn the PROG switch ON.
c. Turn the F2 switch (S2-3) ON and switches F1 (S2-2) and F3 through F5 (S2-4 through S2-6) OFF.
d. With the 1850 EIA Tone LED lit, press and release the Tone Select pushbutton until the “450” EIA Tone LED goes out and no other EIA Tone
LED’s are lit.
e. Turn the Y switch OFF.
f. Turn the PROG switch OFF.
g. The Discrete Split output F2 will now be unresopnsive to the reception of EIA Tones.
Example 3: Re-Assign the Discrete Wildcard F5 Output “OFF” Command from One EIA Tone to Another EIA Tone
After loading Pre-Set #8:
a. Turn the Y switch ON.
b. Turn the PROG switch ON.
c. Turn F1 through F5 (S2-2 through S2-6) OFF.
d. While the F5 “OFF” LED (1050) is lit, press and release the Tone Select pushbutton until the 1150 EIA Tone LED lights.
e. Turn the Y switch OFF.
f. Turn the PROG switch OFF.
g. The F5 Wildcard function will now switch OFF upon reception of the 1150 EIA Tone instead of the 1050 EIA Tone.