CPI Communications TTP216 Series - Manual (Page 7)

B. Options
The TTP200 is programmed by selecting a pre-programmed "EIA Tone-to-Output" assignment pattern, or "Pre-Set." Pre-Sets are available for
several different output options:
1. Discrete 1 of 5 Outputs
Pre-Sets 1 through x assign the 16 standard EIA tones to activate one, and only one, of the "Fx" outputs at a time.
2. Discrete "Split" Outputs
Pre-Sets x though y split the five "Fx" outputs into two groups, one containing “ 1 of 3” outputs F1 through F3 and the other containing “1 of 2”
outputs F4 and F5.
3. Discrete "Wildcard" Outputs
Pre-Sets x though y establish outputs F1 through F4 as discrete outputs and use F5 as a "wild card" output that toggles independently of the other
outputs.
4. BCD Output
Pre-Sets x through y produce a BCD output based on the 16 EIA tones.
5. Customized Output
Once a Pre-Set has been loaded, it can be customized by manually re-programming some or all of the individual EIA Tone-to-Output
assignments. Blank Pre-Sets are provided for each of the four output types (three discrete and one binary) to facilitate building up custom EIA
Tone-to-Output assignments "from scratch."
6. Inverted Output
Leaving S2-2 (F1) ON during normal operation inverts the "Fx" outputs.
TP200 Product Description - 5/23/01 Page 11 of 28
C. Settings and Procedures
1. S2 Setting -- Normal Operation:
OFF OFF OFF OFF OFF OFF OFF OFF
8 7 6 5 4 3 2 1
Y X F5 F4 F3 F2 F1 PROG
2. S2 Setting -- Inverted Outputs:
OFF OFF OFF OFF OFF OFF OFF
ON
8 7 6 5 4 3 2 1
Y X F5 F4 F3 F2 F1 PROG