Hogtunes REV 200SG Kit-RM : 2 Channel Amp / Speakers (2014 - model year) - Manual (Page 5)

3
Step #3: Installing the New Speaker: With the cabinet removed from
bike undo the four screws that hold the factory speaker to the cabinet.
Carefully take off each speaker wire by disconnecting one at a time.
Take a Hogtunes speaker and attach the factory speaker wires, noting
they will only go on one way. The #1 reason for tech related calls
is loose wires at the speaker which is why we designed the
self-locking clips on the speaker frame. Using the factory screws, attach
the Hogtunes 362F-RM speaker to the cabinet noting that there is a
locator “peg” on the cabinet and a hole in the speaker’s frame which
need to line up so the speaker sits flush to the cabinet. Bass response
will be greatly reduced if the speaker is not flush to the
cabinet! The factory speaker grill must be removed and replaced with
the supplied metal mesh grill using the three factory screws on the inside
of the fairing. In the factory grill, you will see two holes and one “key-
hole” where the screws go through and into the fairing. The keyhole on
our grill needs to go in the same spot for proper fitment of the new grill!
With the new grills in place and the speaker properly attached to the
speaker cabinet, the cabinet can be re-installed to the bike. It’s always
a good idea to put the factory fasteners back in to specified torque.
Repeat Step #3 for the second cabinet. Make sure to plug the power
cable back into the power port/cigarette lighter assembly on the brake
side. If your bike has the CB module, make sure to re-install the antenna
cable and main harness.