Hogtunes REV 200SG Kit-RM : 2 Channel Amp / Speakers (2014 - model year) - Manual (Page 8)

6
RoutIng the poweR haRneSS
The balance of the main wire harness will pass under the inner fairing where
the main wire harness passes through on the brake side of the bike. Loosen the
tank console and run wires up and over the gas tank, but under the tank console.
There is a provision on the front of the tank console for wires to pass. Secure
the amplifiers harness to the bikes factory harness using zip ties. When
correctly installed, the power and ground wires are the right length to connect
to the battery.
Attach the amp’s red wire to the positive (+) battery terminal and the amp’s
black wire to the negative (-) battery terminal. The factory battery wires are also
re-installed at this point. When attaching the power and ground wires, it is always
a good practice to do the negative first. When the positive connector touches
the battery, some sparking is normal. This is a function of the capacitors in the
amplifier charging up.
IMPORTANT: With all wires secured, turn the front
wheel to each extreme side making sure that any wires
cannot bind or impede the steering of the motorcycle.
Failure to do so can cause an accident resulting
in serious injury or death!
Turn the stereo on and, at low volume, test to make sure the speakers are working.
Now is a good time to “clean up” and secure the wires using the supplied zip ties.
Stock Harness and Amplifier’s
Harnesses Passing From Fairing
To Just In Front Of Tank (Arrow
A) . Cable Tying the Harnesses
To The Main Bike Harness Just
In Front Of The Tank (Arrow
B) Allows The Amp Harnesses
To Go Up Towards The Tanks
Chrome Console Easier And
Makes For a Cleaner Install.
a
B B
a