Rev 200-rm amplifier installation instructions – Hogtunes REV 200SG Kit-RM : 2 Channel Amp / Speakers (2014 - model year) User Manual
Page 6
4
ReV 200-RM aMplIFIeR
InStallatIon InStRuctIonS
Step #1: Over top of the radio, pull up to release each wire harness from the
black plate via the factory “Christmas Tree” fasteners. If your bike has
factory GPS, the small square antenna will need to be relocated just
behind the voltmeter as shown in Fig 1.1 below. Remove the four factory
T-20 “Torx” screws that go through the top of the black plate and into
the top of the radio.
Step #2:
Step #3: The amplifier comes pre-mounted to a silver mounting plate. Locate and
remove the four screws (2 per side) that attach the amp to the silver plate.
Put these screws just removed and the amplifier aside for now.
Step #4: Sit the supplied silver plate on top of the radio so it is oriented as shown
in Fig 1.2 on the next page. Put one of the supplied star washers on each
factory screw and re-install through the silver plate, through the factory
black plate and into the top of the radio. Locate the main power harness
and plug it into the matching “pig-tail” on the side of the amp. Locate the
supplied input harness and plug into the “audio input” socket on the side
of the amp. Locate the harness with brown/black and blue/black wires
and plug it into the 4 pin BLACK plug on the “pig-tail” coming out of the
amp. Sit the amp on top of the silver plate so when standing in front of
the bike you can read the Hogtunes logo on top of the amp. Locate the
four short black Phillips head screws and secure the amplifier to the
silver plate.
Figure 1.1 - The white
circle shows the new
location for GPS
Antenna if your bike
came factory equipped
with this feature.