Masterbuilt 30-inch Electric Digital Smokehouse Black w/ Top Control (20070910) USER GUIDE - Manual (Page 11)

INSTRUCCIONES DE ENSAMBLAJE
Herramientas requeridas para el ensamblaje: Desarmador Phillips.
Paso 2
Coloque el panel de control en la
parte superior del ahumador.
Alinee la ranura en el conector de
cables, desde el panel de control,
con la lengüeta del conector de
cables en el ahumador, como se
muestra, y conecte.
Paso 1
Ajuste las patas al girar en dirección
a las manecillas del reloj / en
dirección contraria a las manecillas
del reloj para que el ahumador esté
nivelado cuando la unidad este
enderezada. Una vez nivelado,
asegure las posiciones de la pata tra-
sera con las tuercas para ajustar la
tensión que se incluyen.
Tuerca para
ajustar la tension
5
Note: Direct sunlight may interfere with reading LED display,
block light if needed.
To set temperature:
• Press ON button.
• Press SET TEMP button once-LED display will blink.
• Use +/- to set temperature.
• Press SET TEMP button again to lock in temperature.
Note: Heating will not begin until timer is set.
To set timer:
• Press SET TIME button once-LED display for hours will blink.
• Use +/- to set hours.
• Press SET TIME button again to lock in hours.
The minutes LED will start blinking.
• Use +/- to set minutes.
• Press SET TIME to lock in minutes and start cook cycle.
Heat will turn off when time has expired.
To RESET control panel:
If control panel shows an error message, turn electric smoker off, unplug unit from outlet, wait ten seconds, plug unit
back into outlet, then turn electric smoker on. This will reset control panel.
CONTROL PANEL OPERATING INSTRUCTIONS
TROUBLESHOOTING GUIDE
Symptom Cause Possible Solution
Power light won’t come on
Not plugged into wall Check wall connection
House fuse tripped
Make sure other appliances are not
operating on the same electrical circuit.
Check household fuses.
Wire connector on controller not properly
connected to smoker
See Step 2 on Page 5
Controller malfunctioning Contact Masterbuilt at 1.800.489.1581
Unit takes excessive amount of time to
heat up (longer than 60-70 min)
Unit plugged into an extension cord
Set unit so an extension cord does not
have to be used
Door not closed properly Close door and fasten latch securely
Controller malfunctioning Contact Masterbuilt at 1.800.489.1581
There is a gap between the door and
the smoker when in use
Latch not holding door closed
Adjust latch to hold door tighter against
body
Door alignment Contact Masterbuilt at 1.800.489.1581
Damaged door seal Contact Masterbuilt at 1.800.489.1581
Grease is leaking out of smoker through
door and legs
Drip pan not in place
Reposition so hole lines up with drain
hole in bottom of unit
Excess grease or oil build-up in unit Clean unit
Drain tube in back of unit is not draining
Check drain tube positioning at back of
unit
No smoke No wood chips Add wood chips See Page 9
Temperature rapidly decreased, or shut
down after few hours of use
Faulty control unit Contact Masterbuilt at 1.800.489.1581
Controller displaying error message Further troubleshooting required Contact Masterbuilt at 1.800.489.1581
Power light is on, unit isn’t heating Further troubleshooting required Contact Masterbuilt at 1.800.489.1581
Controller does not adjust heat Further troubleshooting required Contact Masterbuilt at 1.800.489.1581
10