Altinex MT109-100 - Manual (Page 12)

MULTITASKER™
400-0095-005 11
11
Command Format: [CnUiS]
Cn = card number
S
= save configuration
Example:
Save the card's current settings by sending the
command [C4S]. The feedback will display the
status and a save message.
ON1C04
OUTVOL=32/32
INVOL1=16/32
INVOL2=16/32
INVOL3=16/32
INVOL4=16/32
INVOL5=16/32
INVOL6=16/32
INVOL7=16/32
INVOL8=16/32
[SAVED]
FEEDBACK COMMANDS ?, ?Cn and STA
The next four commands are a function of both
the card and the front panel and are only
available with MultiTasker Front Panel systems
that have the following firmware:
690-0122-015 = Version 015 or later.
690-0123-004 = Version 004 or later.
690-0124-018 = Version 018 or later.
Send the command [VER], and the system will
respond with feedback that includes the
following:
690-0122-015 690-0123-004 690-0124-018
Check the last three digits against the numbers
above to determine if the option is available.
4. [?]
This command will display general information
about the MultiTasker and cards installed in the
unit.
Command Format: [?Ui]
Ui = Unit ID (i = from 0 to 9)
Example:
A MultiTasker with Unit ID #1 has a front panel
with part number MT101-101 and contains an
MT103-122, MT103-123 and MT109-100. Send
the command [?U1] and receive the following
feedback:
[(MT101-101U1)(MT103-122C01)
(MT103-123C02)(MT109-100C03)]
MT101-101U1 = Panel Number and Unit ID
MT103-122C01 = An MT103-122 is in slot 1
MT103-123C02 = An MT103-123 is in slot 2
MT109-100C03 = An MT109-100 is in slot 3
5. [?C]
This command will return general information
about the card and its status.
Command Format: [?CnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui
= Unit ID (i = from 0 to 9)
Example:
The MT109-100 in slot 4 has Input 1 turned on
with a gain level of 16 on the input and a volume
level of 32 on the output. Send the command
[?C4] to receive feedback status similar to the
following.
[(MT109-100C05)(VR690-0179-006C05)
(IN1C05)(VO32C05)(VI1632323232323232C05)
(VM0C05)]
All status feedback is enclosed in brackets, “[ ]“.
Each data field within the status is enclosed in
parentheses. The first two characters identify
the status type. The last three characters are
the card’s ID.
MT109-100 = Card model number
VR690-0179-006 = Firmware version
IN1 = Input selection
VO32 = Output volume
VI1632323232323232 = Input levels
VM0
= Mute on/off
The input selection line shows the active input
number is Input 1. The possible values are 1-8.