Altinex MT109-100 - Manual (Page 20)

MULTITASKER™
400-0095-005 19
19
Example:
Group 5 consists of cards 2, 4 and 6. Group 2
consists of cards 1, 2, 3, 4 and 5. Delete all the
groups by sending the command [RMG
* ]. The
system will return the following feedback:
G1-G8:EMPTY
45. [RD]
This command reads and then displays the
members in each group.
Command Format: [RDGkUi]
Gk = Group ID (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
The cards in slots 2, 4 and 6 are part of
Group 5. Read the member data for Group 5,
by sending the command [RDG5]. The system
will return feedback as follows:
[G5=C2C4C6]
The feedback shows G5 (Group 5) and then the
cards that make up Group 5. In this case,
Group 5 includes C2, C4 and C6.
7.3. SUMMARY OF COMMANDS
Card Commands
1) [VER] Display software version
2) [C] Display card status
3) [CnS] Save card settings
4) [?] Display system cards
5) [?C] Display card information
6) [STA1] Enable auto feedback
7) [STA0] Disable auto feedback
8) [ +O ] Increment output volume
9) [ -O ] Decrement output volume
10) [ +I ] Increment input gain
11) [ -I ] Decrement input gain
12) [ + ] Increment value by one
13) [ - ] Decrement value by one
14) [SEL] Select input level to adjust
[SELm] Select output volume to adjust
15) [VLO] Set output volume level
16) [VLI] Set an input level
17) [RUP] Ramp volume UP to 32
18) [RUP=] Ramp volume UP to a value
19) [RDN] Ramp volume DOWN to 1
20) [RDN=] Ramp volume DOWN to a value
21) [RAMP] Return ramp rate
22) [RAMP=] Set ramp rate
23) [RST] Stop ramping
24) [CLR] Reset card to default values
25) [ONm] Select the active input
26) [ON] Enable output
27) [OFF] Disable output
28) [MUT0] Enable output
29) [MUT1] Disable output
30) […S] Save command configuration
31) […F] Display feedback upon sending
32) […P] Set the path, preload for [SW]
33) [SW] Switch preloaded output buffer
34) [TEST] Perform board memory test
35) [FBD] Enable/disable feedback delay
36) [RSI] Reset Card IDs to defaults
37) [SIDn] Set all Card IDs
38) [SIDnCi] Set one Card ID
39) [SID+] Set all Card IDs to an offset
40) [RSN] Display card slot number
41) [HELP] Display available commands