Revolabs Fusion User Guide - Manual (Page 11)

Page 11
• With the microphone in position, un-mute the microphone by pressing and
releasing the Mute button (confirm by viewing flashing GREEN LED).
• To turn microphone off, return the microphone unit to the Charger Base
or press and hold the Mute button for ~10 seconds until the LED turns
solid RED and release button.
• If the microphones are placed too far from the Base Station (~100 feet or
30 meters) the connection will be dropped (LED flashes all colors) and the
microphone will mute. After 15 seconds the microphone will beep 5 times,
and will continue beeping every 30 seconds to indicating it’s out of range.
• Move the microphone closer to the Base Station and the connection will
automatically be re-established to its original state, and the beeping will
cease. If not, the microphone will continue beeping until it turns off in
about 15 minutes.
Muting Microphones
In the default setting, each Solo microphone will mute only itself when its MUTE
button on the microphone is pressed. To mute all of the microphones, press
the red MUTE button on the Remote Control; all microphones will flash red
and no individual microphone can be unmuted until the remote MUTE button is
pressed again. All microphones will return to their prior state.
However, if the tabletop microphone master mute has been enabled (Refer to
Set-Up Guide), the mute will work as follows: in addition to the Remote
Control MUTE button muting all of the microphones, the Solo Tabletop
microphone MUTE button will also act as a master mute and mute all active
microphones. Pressing any Tabletop microphone MUTE button or the Remote
Control MUTE button will unmute all tabletop microphones. All wearable and
handheld adapter microphones in use will return to their prior state.
Revolabs Fusion™