Revolabs Fusion User Guide - Manual (Page 12)

Using the Solo XLR Microphone Wireless Adapter
The Revolabs Solo™ Universal Wireless Adapter for Handheld Microphones,
shown in the following figure, is connected to your existing handheld dynamic
microphones for wireless freedom during open microphone meetings, Q&A
sessions, classrooms, etc.
1. Mute button — press to mute, un-mute and pair microphone
2. Rubber collar — durable and impact/strain protection
3. XLR Female connector — balanced audio for dynamic microphones
4. LED display — visual status for mute, un-mute, and pairing
5. Audio Out port — accepts the 2.5mm plug for the earpiece
6. Power/Charging Port — docks to Charger Base
To use the Revolabs Solo™ Universal Wireless Adapter:
Remove the Microphone Adapter from the Charger Base.
The adapter turns on and mutes automatically when removed from Charger
Base (flashing RED LED). The XLR Microphone Adapter is attached to a
standard dynamic microphone to convert it from a wired microphone to a
wireless microphone (see following figure).
The Adapter does not provide phantom power or bias current so it cannot be
used with condenser or electret microphones.
With the microphone attached, un-mute the Adapter by pressing and releasing
the Mute button (confirm by viewing flashing GREEN LED).
NOTE: If the microphone has an on-board mute switch, this switch must also be un-
muted prior to use.
Page 12
User’s Guide