Revolabs Fusion User Guide - Manual (Page 5)

Revolabs Fusion™
NOTE: In the default setting, each Solo microphone will mute only itself when
its MUTE button on the microphone is pressed. To mute all of the
microphones, press the red MUTE button on the Remote Control; all
microphones will flash red and no individual microphone can be unmuted until
the remote MUTE button is pressed again. All microphones will return to their
prior state.
However, if the tabletop microphone master mute has been enabled (Refer to
Set-Up Guide), the mute will work as follows: in addition to the Remote
Control MUTE button muting all of the microphones, the Solo Tabletop
microphone MUTE button will also act as a master mute and mute all active
microphones. Pressing any Tabletop microphone MUTE button or the Remote
Control MUTE button will unmute all tabletop microphones. All wearable and
handheld adapter microphones in use will return to their prior state.
End a Call
To end a call, the user must push “End", even if the other callers have hung up.
Redial a Call
To redial a the last phone number, push “Redial”.
Adjust Volume
To increase and decrease the volume , use the Vol + and Vol- buttons.
Flash Button
“Flash” works according to your phone system.
Page 5