Altinex MT113-101 - Manual (Page 12)

MULTITASKER™
400-0209-002 11
11
690-0122-015 = Version 015 or later.
690-0123-004 = Version 004 or later.
690-0124-018 = Version 018 or later.
NOTE: In MTSetup™, send the command
[VER] from the Terminal Window. The system
will respond with feedback similar to the
following:
[690-0122-015 690-0123-004 690-0124-018]
Check the last three digits against the numbers
above to determine if the option is available.
Command Format: [?CnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = from 0 to 9)
The MT113-100/101 is in slot #4. Send the
command [?C4] to receive the feedback status.
All status feedback is enclosed in brackets, “[ ]“.
Each data field within the status is enclosed in
parentheses. The first two characters identify
the status type. The last three characters are
the card’s ID.
[(MT113-100C04)(VR690-0133-009C04)
(VO16C04)(VI161616C04)(VB08C04)
(VT08C04)(VL01C04)(VM0C04)]
MT113-100 = Card Type
VR690-0133-009 = Firmware version
VO16
= Output Volume Level=16
VI161616 = Input volume levels
VB08 = Bass level = 08 out of 16
VT08 = Treble level = 08 out of 16
VL01 = Loudness (00=ON, 01=OFF)
VM0 = Mute (0=OFF, 1=ON)
The Input Volume status line is read from left to
right as outputs one through three. Each volume
level is 2 digits, in this case, each is set to 16.
6. [STA]
This command enables/disables automatic
feedback from the front panel. The command
affects any card with auto-feedback capability,
not just the MT113-100/101. The default at
power on or reset is STA0, OFF.
Command Format [STA1] = ON
Command Format [STA0] = OFF
Feedback Prefix Definitions:
VR
= Firmware Version
VO = Output Volume
VI = Input Volume
VB = Bass Volume
VT = Treble Control
VL = Loudness Control
VM = Mute Control
Example:
Command = [VLOA12C04]
Feedback = (VO12C04)
VO
= Output Volume
12 = Output volume level12
C04 = Card slot number
7. […S] – SAVE
This command will save the configuration
command being sent in memory. When
sending the command [VLBA12C4S], after reset
or power up, the bass level on C4 will be 12 out
of 16.
8. […F] – FEEDBACK
After processing a command, an OK or ER will
be returned as feedback if "F" is included at the
end of some command strings.
9. [ + ] and [ - ]
These commands allow a selected property to
be adjusted from keyboard commands or
programmed front panel buttons.
Command Format: [ + ], [ - ]
[+] = Increment level by one step
[-] = Decrement level by one step