Altinex MT113-101 - Manual (Page 20)

MULTITASKER™
400-0209-002 19
19
REMOVE ALL GROUPS
Remove all the members from every group,
effectively deleting all groups.
Command Format: [RMG *Ui]
Ui = Unit ID (i = # from 0-9)
Example:
Group 1 consists of cards 1 and 2. Group 2
consists of cards 1, 2, 3, 4 and 5. Delete all the
groups by sending the command [RMG
*]. The
system will return the following feedback:
G1-G8:EMPTY
41. [RD]
This command reads and then displays the
members in each group.
Command Format: [RDGkUi]
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
The cards in slots 1, 2 and 19 are part of
group 5. Read the member data for group 5, by
sending the command [RDG5]. The system will
return feedback as follows:
G1=C1C2C19
The feedback shows G1 (Group 1) and then the
cards that make up Group 1. In this case,
Group 1 includes C1, C2 and C19.
42. [CLM]
This command removes the members in a
group and leaves the group empty. It is
equivalent to sending the [RMGkUi] command
without card references.
Command Format: [CLMGkUi]
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
Group 5 of Unit ID 1 contains the cards in slots
1, 2 and 19. Read the member data for group 5
of Unit ID 1. Send the command [RDG5U1] and
receive the following feedback:
G1=C1C2C19
Now, clear group 5 by sending the command
[CLMG5U1]. Reread the member data as above
and note the following feedback:
G1=EMPTY
7.3 SUMMARY OF COMMANDS
Card Commands
1) [VER] Receives software version
2) [C] Receives status of the card
3) [CnS] Save card settings
4) [?] Show system cards
5) [?C] Show card information
6) [STA] Enable/disable auto feedback
7) […S] Save the command being sent
8) […F] Show command feedback
9) [ + ] [ - ] Increments and Decrements
10) [SELI] Select input volume to adjust
11) [SELO] Select output volume to adjust
12) [SELB] Select to adjust bass level
13) [SELT] Select to adjust treble level
14) [VLOA] Set absolute output volume
15) [VLI] Set absolute input volume
16) [VLBA] Set absolute bass level
17) [VLTA] Set absolute treble level
18) [LOD0] Turn ON loudness feature
19) [LOD1] Turn OFF loudness feature
20) [MUT0] Turn ON speaker output
21) [MUT1] Turn OFF speaker output