Kodak PULSE - 10 Inch - Manual (Page 17)

Getting started
www.kodak.com/go/pulseframesupport 10
2 If your network is secure, touch Specify security code, then enter the
security code for your network. If you do not know your security code, ask the
person who set up your network.
3 If a PIN is required for your network, touch Advanced PIN, then enter your
PIN. (The PIN is commonly found on the router itself). If you do not know your PIN,
ask the person who set up your network.
4 Continue with Activating your frame—www.kodakpulse.com, page 7 to finish
your setup.
Network is not shown after network scan
If your wireless network is not shown after the network scan ( see page 5 ), try the
following:
1 Move your digital frame closer to the router, then
touch Refresh .
2 If your wireless network is still not shown, your
network name (SSID) may not be broadcast. To
enter it manually, touch Non-Broadcast
.
The on-screen keyboard appears.
3 Enter your SSID (also called network name). If you
do not know your SSID, ask the person who set up
your network.
NOTE: SSIDs are case sensitive.
If your network is secure, when prompted, enter the security code for your
network.
NOTE: Security codes may be case sensitive.
4 When finished, touch OK.
5 Continue with Activating your frame—www.kodakpulse.com, page 7 to finish
your setup.