ADC 410F User Manual
Page 57
Chapter 6: Configuring the Ports
Megabit Modem 410F and 420F User Manual
49
2
Enter the bridging configuration parameters:
3
Enter the routing configuration parameters:
4
Enter the LAN and WAN port configuration parameters:
Select
Bridging Enable
to forward Ethernet data based on MAC addresses.
Click
Spanning Tree Enable
to enable the Spanning Tree protocol.
The Spanning Tree protocol eliminates loops in a bridged LAN topology. When
Spanning Tree is selected, it becomes active when bridging is enabled. If the
modem is configured for routing only, Spanning Tree does not run. See
“Spanning Tree Protocol” on page 69
for more information.
Select
Routing Enable
to forward IP datagrams based on IP addresses. See
for more information.
Click
Static Route Table
to get a dialog to set up static routes. The modem can accept
up to 32 static route entries. Go to
“Defining Static Route Entries” on page 51
to
configure these parameters.
Enter the
LAN IP Address
for the modem Ethernet 10/100BASE-T LAN port. The
default IP address for the LAN port is 192.168.0.1.
Enter the
WAN IP Address
for the ADSL (WAN) port. This option is available only if
routing is enabled and you must enter a valid IP address. When routing is not
enabled, the field is blank.
Enter the
LAN IP Net Mask
(subnet IP mask) for the modem Ethernet 10/100BASE-T
LAN port. The default IP subnet mask is 255.255.255.0.
Enter the
WAN IP Net Mask
(subnet IP mask) for the ADSL (WAN) port. This option
is available only if routing is enabled and you must enter a valid subnet mask. When
routing is not enabled, the field is blank.
The
LAN Bridge Port Priority
is preset to
100
. Bridge Port Priority is used when
Bridging
mode and
Spanning Tree
are both enabled and determines which modem port has
higher priority when active simultaneously.
The
WAN Bridge Port Priority
is preset to
101
. Bridge Port Priority is used when
Bridging
mode and
Spanning Tree
are both enabled and determines which modem port
has higher priority when active simultaneously.