Lenovo LI2821 Wide LCD Monitor - Manual (Page 13)

9. Connect one end of source input (like VGA) cable to the monitor and the other end to the
computer. Connect one end of other source input (like DP) cable to the monitor and the
other end to the computer. Use the OSD controls to enter the PIP/PBP mode.
PIP/PBP
Note: The source input should follow below table.
PIP/PBP Input Pairing Limitation
HDMI HDMI/MHL VGA DP
HDMI No Yes Yes Yes
HDMI/MHL Yes No Yes Yes
VGA Yes Yes No Yes
DP Yes Yes Yes No
10. Insert the Adapter into the monitor, then plug the monitor power cord and the computer
cord into grounded electrical outlets.
Note:A certified power supply cord has to be used with this equipment. The relevant
national installation and or equipment regulations shall be considered. A certified power
supply cord not lighter than ordinary polyvinyl chloride flexible cord according to IEC
60227 (designation H05VV-F 3G 0.75mm2 or H05VVH2-F2 3G0.75mm2) shall be used.
Alternative a flexible cord be of synthetic rubber according to IEC 60245 (designation
H05RR-F 3G 0.75mm2) shall be used.
Chapter 1.
1-9