Acomdata.com RPDOCKU2FA - Manual (Page 38)

operate at USB 1.x speeds. You will need to follow any necessary
set-up instructions for each RocketPod module, as described in their
respective User’s Guides.
Q: I stacked on a RocketPod module and it powered on but my
computer did not recognize it.
A: Make sure you properly followed the set-up instructions for that
device. Each RocketPod peripheral has it’s own set-up requirements
independent of the DockPod. Also, check to make sure that you are
using the correct interface and that it is properly connected. For
example, if the RocketPod module you stacked onto your DockPod
uses a USB 2.0 interface, make sure you properly connect the
DockPod’s USB 2.0 interface to your computer or USB hub.
Q: I have a RocketPod module stacked onto my DockPod, but the
Stack light is not on.
A: First, make sure your DockPod is turned on. If it is, the most likely
cause is the module is not properly seated on the DockPod. Remove
the module and re-connect it, following the connection procedure in
this guide. If your stacked-on modules are recognized by your com-
puter and functioning fine but the Stack light is not illuminated, there
is a problem with the light itself.
36