Lenovo ThinkServer RS140 User Manual
Page 95
To remove and reinstall the slim-optical-drive bracket, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,
clean, and static-protective surface.
3. Remove the server cover. See “Removing the server cover” on page 55.
4. Locate the slim-optical-drive bracket in the server. See “Server components” on page 17.
5. If there is a slim optical drive installed, remove it from the server. See “Removing the slim optical
6. Lift the release pin
1
of the slim-optical-drive bracket. Then, slide the bracket to the rear of the server
as shown to release the bracket from the server. Lift the slim-optical-drive bracket out of the chassis.
1
Figure 55. Removing the slim-optical-drive bracket
.
Installing, removing, or replacing hardware
83