ASRock 939Dual-SATA2 - Manual (Page 20)

2 0 2 0 2 0 2 0 2 0
2.8 2.8 2.8 2.8 2.8 Serial A Serial A Serial A Serial A Serial ATTTTTA (SA A (SA A (SA A (SA A (SATTTTTA) Hard Disks Installation A) Hard Disks Installation A) Hard Disks Installation A) Hard Disks Installation A) Hard Disks Installation
This motherboard adopts JMicron JMB360 chipset that supports Serial ATAII
(SATAII) hard disk. It also adopts ULi M1567 south bridge chipset that supports
Serial ATA (SATA) hard disks, and supports RAID functions. You may install SATA
hard disks on this motherboard for internal storage devices. This section will
guide you to install the SATA hard disks.
STEP 1: Install the SATA hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard’s SATA
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA hard disk.
1. If you plan to use RAID 0, RAID 1, or JBOD functions on SATA, SATA
HDDs must be operated in “RAID” mode.
2. “RAID” and “non-RAID” mode are options under “SATA Operation Mode” in
BIOS setup. Please refer to page 30 for details. They need different drivers
during actual operation.
2.9 2.9 2.9 2.9 2.9 Making a SA Making a SA Making a SA Making a SA Making a SATTTTTA Driver Disk A Driver Disk A Driver Disk A Driver Disk A Driver Diskette F ette F ette F ette F ette For SA or SA or SA or SA or SATTTTTA Operation in A Operation in A Operation in A Operation in A Operation in
“RAID” Mode “RAID” Mode “RAID” Mode “RAID” Mode “RAID” Mode
If you want to install Windows 2000, Windows XP, or Windows XP 64-bit OS on your
SATA HDDs, you will need to make a SATA driver diskette before you start the OS
installation.
STEP 1: Insert the ASRock Support CD into your optical drive to boot your system.
(Do NOT insert any floppy diskette into the floppy drive at this moment!)
STEP 2: During POST at the beginning of system boot-up, press <F11> key, and
then a window for boot devices selection appears. Please select CD-
ROM as the boot device.
STEP 3: When you see the message on the screen, “Do you want to generate
Serial ATA driver diskette [YN]?”, press <Y>.
STEP 4: Then you will see these messages,
Please insert a diskette into the floppy drive.
WARNING! Formatting the floppy diskette will
lose ALL data in it!
Start to format and copy files [YN]?
Please insert a floppy diskette into the floppy drive, and press <Y>.
STEP 5: The system will start to format the floppy diskette and copy SATA drivers
into the floppy diskette.