Avital Hurricane 2 - Manual (Page 11)

Programming Your Remote Controls
The system allows the user to add new remote controls in one step, delete
lost or stolen remote controls or rearrange the factory preset remote control
configuration.
All remote control programming features are accomplished by turning the
ignition key on (or starting the vehicle) and flicking the valet switch on and
off a preset number of times.
1. Remove the system from Protected Valet Mode. Programming cannot be
accessed while the system is in Protected Valet Mode, indicated by the
system LED on solid red.
2. Select the feature you wish to program from the "Programming Table for
Remote Controls." Note the number of chirps.
3. Turn the ignition key to the "ON" position.
4. Within 10 seconds, begin flicking the valet switch on and off. The siren
will chirp one time each time you flick the switch on, then off.
5. Continue flicking the valet switch on and off until you reach the number
of chirps associated with your chosen feature.
NOTE: Stop on the chirp.
6. Follow the "Secondary Action."
7. Turn the ignition key off.
8. Repeat steps 1-7 for any other feature you wish to program.
Pro gram ming Ta ble for Re mote Con trols
Fea ture
Fac tory
Set ting
# of
Chirps
Sec on dary Ac tion
Arm/Disarm/Remote
Panic
Channel 1
Button 1
12
Press any remote control button you choose to operate
this feature. Siren will chirp once for confirmation.
Accessory (-) Output
Channel 2
Button 2
13
Press any remote control button you choose to operate
this feature. Siren will chirp twice for confirmation.
Silent Arm/Disarm
Channel 3
Button 3
14
Press any remote control button you choose to operate
this feature. Siren will chirp 3 times for confirmation.
Accessory (-) Output
Channel 4
Buttons 1 & 2
15
Press any remote control button you choose to operate
this feature. Siren will chirp 4 times for confirmation.
11
Hurricane 2 Owner's Manual