Operating instructions – Avital Hurricane 2 User Manual

Page 5

Advertising
background image

Operating Instructions

n

Remote Control

— Each of the pair of remote controls is a miniature

radio transmitter powered by a +12 volt battery with a typical range of up
to 100 feet. Obstructions, radio interference, cellular transmissions or a
weak remote control battery may reduce the range or interrupt
transmission. (If the system does not immediately respond, release and
press the button again. This works better than holding the button down.)
The second remote can be used by a second driver, or kept as a spare.

Additional remote controls or batteries can be purchased from any
authorized Avital Dealer, or by calling Avital Technologies toll-free at
1-800-253-0334 (within the U.S.) or 1-847-215-2233.

n

To Arm The System

— Your alarm system can be programmed for

active or passive arming. Active arming means the system can only be
armed with the remote control. Passive arming means the system will
automatically arm itself. See the "Programming Table for system
Features" on page 9.

n

Ac tive Arm ing.

Press remote button #1 for 1-2 seconds. The siren

will chirp twice, the parking lights will flash twice, the doors will
lock, the LED will flash slowly and the starter will be disabled.

n

Pas sive Arm ing.

Turn the ignition key off, exit the vehicle and close

the doors. 30 seconds after the interior light turns off the siren will
chirp twice, the parking lights will flash twice, the LED will flash
slowly and the starter will be disabled (at any time during passive
arming, the system can be actively armed).

n

To Disarm the System

— Press remote button #1 for 1-2 seconds.

The siren will chirp once, the parking lights will flash once, the doors
will unlock, the interior lights will turn on, the LED will turn off and the
starter will be enabled.

n

Remote-Controlled Silent Arm/Disarm

— Press remote button #3

for 1-2 seconds.

5

Hurricane

2

Owner's Manual

Advertising