Audible 2220 - Manual (Page 37)

37
# ln –sf /etc/init.d/hptdriver /etc/rc.d/rc4.d/S01hptdriver
Step 3 Configure System to Automatically Load the Driver (continued)
# ln –sf /etc/init.d/hptdriver /etc/rc.d/rc5.d/S01hptdriver
Step 4 Configure System to Mount Volumes during Startup
The system can be instructed to automatically mount the array(s) during startup by modifying the
file”/etc/fstab”.
For example, add the following line to tell the system to mount /dev/sda1 to location /mnt/raid after startup:
/dev/sda1 /mnt/raid ext3 defaults 0 0
4 - Updating the Driver
1. If the original driver is installed in the system’ s initrd (Initial RAM Disk) file (when using a system
installed to Rocket RAID 2220 controller, for example), the driver module in t he initrd file should be
updated using the mkinitrd command (or extract the initrd file and replace the driver module
manually).
2. If the original driver is installed in the /lib/modules/`uname –r`/kernel/drivers/scsi/ directory, and
loaded by the script file (Example /etc/init.d/hptdriver) during the init process, or the configure file
(Example /etc/modules.conf), please replace it with the new driver (hptmv 6.ko).
5 - Uninstalling the Driver
To uninstall the RocketRAID 2220 driver
Note: The driver cannot be uninstalled while the system is booted from a disk or array attached to the
Rocket RAID 2220.
To uninstall the driver, remove the lines added to /etc/fstab, and remove the files created in the /etc/init.d
directory.