Airlink UG-ASW232-1103 - Manual (Page 18)

32-Port 10/100Mbps Ethernet Switch User Guide
18 AirLink+
LED Indicators
The LED indicator panel contains the following indicators:
•
Power (PWR) Power (PWR) Power (PWR) Power (PWR) Power (PWR)
⎯This indicator lights green when the
switch is receiving power. Otherwise, it is off.
•
Full-Duplex/Collision (Full-Duplex/ Full-Duplex/Collision (Full-Duplex/ Full-Duplex/Collision (Full-Duplex/ Full-Duplex/Collision (Full-Duplex/ Full-Duplex/Collision (Full-Duplex/
Collision)
Collision) Collision) Collision) Collision)
⎯This LED indicator lights green when a
respective port is in full duplex (FDX) mode. Otherwise,
it is blinking when collisions are occurring on the
respective port.
•
Link/Activity (gr Link/Activity (gr Link/Activity (gr Link/Activity (gr Link/Activity (green/amber) een/amber) een/amber) een/amber) een/amber)
⎯This indicator lights
green when the port is connected to a 100Mbps Fast
Ethernet station. If the indicator blinks green, data is
tranmitted or received on the 100Mbps network. If the
indicator lights amber, the port is connected to a
10Mbps Ethernet station. If the indicator blinks amber,
data is tranmitted or received on the 10-Mbps network.
•
100 BASE-FX Module Indicator (gr 100 BASE-FX Module Indicator (gr 100 BASE-FX Module Indicator (gr 100 BASE-FX Module Indicator (gr 100 BASE-FX Module Indicator (green) een) een) een) een)
⎯This
indicator lights up green when a module is installed.
Connecting the Switch
This chapter describes how to connect the Switch to your
Fast Ethernet network.
Connecting a PC to the Switch
A PC can be connected to the Switch via a two-pair
Category 3, 4, 5 UTP/STP cables. Connect the PC (equipped
with a RJ-45 10/100Mbps phone jack) to any of the 32 ports
(1 to 32)