AGFA 1200 - Manual (Page 18)

Chapter 2: Installing the Scanner 18
-or-
If SCSI ID number 2 is already assigned, you need to set the scanner to a free SCSI ID
number.
$ Make sure that your scanner is switched off.
$ Decide on an unassigned SCSI ID number.
$ Use the SCSI ID switch at the rear of the scanner to set the desired SCSI ID:
$ Press – to decrease the SCSI ID number.
-or-
Press + to increase the SCSI ID number.
4 Click OK to close the SCSI ID Checker.
Connecting the Scanner
Before you connect the scanner to your Macintosh, make sure that your scanner as well as your
Macintosh and everything connected to it are switched off.
A terminator and a SCSI cable are supplied with your scanner.
Caution : For safety reasons, never use extension cables for power cords. Always make sure that
there is no more than one terminator in your SCSI chain and that it is placed at the end of the
chain. Some SCSI devices have built-in terminators and must therefore be placed at the end of
your SCSI chain. Please check the documentation of each of your SCSI devices if you are not sure
whether the device has a built-in terminator or not. Your Arcus 1200 has no built-in terminator.