AGFA 1200 - Manual (Page 38)

Chapter 3: Placing Originals 38
Placing Transparent Originals
When you scan transparent originals, there are two possibilities:
# You can use the glass plate and the flexible template;
# You can use the batch slide holders. The batch slide holders fit into the batch slide holder
frame which you insert in the scanner.
Using the Glass Plate and the Flexible Template
To scan a transparent original, carry out the following instructions:
1 Open the TPU of your scanner.
" Note: Make sure the glass plate is inserted, otherwise the TPU is locked.
2 Place the flexible template on the glass plate.
3 Center the original on the template so that its top side is directed towards the calibration slit.
" Note: Make sure that the calibration slit of the flexible template is at the front side and that it is
clean.
Using the Batch Slide Holders
The batch slide holders are available in order to increase the productivity of the scanner. The
concept of the batch slide holders is developed so that a variety of combinations are possible.
The base is the batch slide holder frame in which different kinds of batch slide holders can be
mounted. The batch slide holders keep the originals perfectly flat between two plastic frames, thus
guaranteeing optimum sharpness.
1 Put your original face down in the appropriate batch slide holder.