Konica Minolta Printgroove - Manual (Page 86)

Start Printgroove POD Ready 4
Printgroove POD Ready 4-5
2
Note
– [Proof Generation] is only needed to use [Send Proof] on the Print-
groove POD Ready with Guide mode.
– About the detail of procedures to create permissions set, please re-
fer to the User’s Guide of Printgroove POD Guide.
Node
When the node of the Workflow changes to the node of which node type is
[Printgroove POD Ready], the user can check-out.
The node for Printgroove POD Ready are as follows;
-
[Ready Assigned]: The assigned user can check-out from Workflow. This
node has no constraints for the node which follows it.
- [Ready Pool]: The user of Printgroove POD Ready can Grab the job as
part of the check-out process. This node has a constraint that [Ready]
node must follow it.
- [Ready]: After the user Grab the job of [Ready Pool] node, the node shifts
to this node. This node follows after [Ready Pool] node.
[Ready Assigned] node has the following settings;
-
[Node Name]: Ready Assigned or any strings
- [Node Type]: Printgroove POD Ready
- [Status]: Ready Assigned
[Ready Pool] node has the following settings;
-
[Node Name]: Ready Pool or any strings
- [Node Type]: Pool
- [Status]: Ready Pool
[Ready] node has the following settings;
-
[Node Name]: Ready or any strings
- [Node Type]: Group
- [Status]: Ready or any strings
Before using with the Guide mode, create the node on Printgroove POD
Guide.
The dialog for Node setting on Printgroove POD Guide is as follows;