AT&T TL7700 - Manual (Page 21)

17
Getting started
To attach the neck band to the headset:
Remove any headset attachment (earbud excluded) currently (earbud excluded) currently currently
connected to the headset.
Insert the earpiece into the neck band ring as shown in Figure 9.
Push the earpiece towards the neck band ring until it clicks
into place as shown in Figure 10.
4. Place the neck band around your neck with the padded neck
band rings over your ears.
5. Adjust and rotate the angle of the headset until the microphone
is pointing towards your mouth as shown in Figure 11.
NOTE: To wear on your other ear, remove the headset from the neck band
(see page 18) and then attach it to the other side of the neck band by
following the steps above.
1.
2.
3.
Headset attachments
Behind-the-neck band
Figure 9 Figure 10
Figure 11