Konica Minolta SC-215 - Manual (Page 30)

- 4-2
4.1 INSTALLATION PROCEDURE
Installation procedures of the SC-215 driver and utilities are as
follows:
1. Start Microsoft Windows.
2. Insert the Utilities and Documentation CD-ROM into your
CD-ROM drive.
3. The CD-ROM will autolaunch on most systems. However,
if your system does not support autolaunching CD-ROMs,
from the Start button, choose RUN, type
x:\driver\Setup.exe (x: the CD-ROM drive in use), and then
choose OK. (See Figure 4-1,4-2)
4. Follow the on-screen instructions to complete the
installation. (You may also need to follow the instructions
shown on the Add New Hardware Wizard to let Windows
identify your new USB device before or after the driver
installation.).
Fig. 4.1
Fig. 4.2