Alamo RHINO SM72 - Manual (Page 101)

OPERATION
SM72 02/10 Operation Section 4-9
© 2012 Alamo Group Inc.
OPERA
T
ION
4. STARTING THE SKID STEER
The operator must have a complete understanding of the placement, function, and operational use of all skid
steer controls before starting the skid steer. Review the skid steer operator’s manual and consult an
authorized dealer for operating instructions if needed.
Essential Skid Steer Controls:
• Locate the light control lever
• Locate the engine shut off control
• Locate the brake pedals and the clutch
• Locate the auxiliary hydraulic control lever.
• Locate the boom height foot controls.
• Locate the hitch tilt foot controls.
Before starting the skid steer ensure the following:
• Conduct all pre-start operation inspection and service according to the skid steer operator’s manual.
• Make sure all guards, shields, and other safety devices are securely in place.
• The parking brake is on.
• The skid steer transmission is in neutral.
• The auxiliary hydraulics are disengaged.
• The boom height/tilt controls are in the neutral position.
Refer to the skid steer owner’s manual for procedures to start the skid steer. Only start the skid steer while
seated and belted in the operator’s seat. Never bypass the ignition switch by short circuiting the starter
solenoid.
After the engine is running, avoid accidental contact with the skid steer transmission to prevent sudden and
unexpected skid steer movement. OPS-SS-0022
Never run the Power Unit engine in a closed building or without adequate ventilation. The
exhaust fumes can be hazardous to your health.
(SPU-23)
Start the Power Unit only when properly seated in the Power Unit seat. Starting
a Power Unit in gear can result in injury or death. Read the Power Unit
Operator’s Manual for proper starting instructions.
(SPU-19)