Xerox WorkCentre C2424-3833 - Manual (Page 156)

Connections and Internet Protocol (TCP/IP)
WorkCentre® C2424 Copier-Printer
6-6
Dynamic Methods of Setting the System’s IP Address
You can set the system’s IP address using any of the following methods.
■ DHCP
■ CentreWare IS
■ AutoIP
Enabling DHCP on the System
Verify that the system DHCP protocol is enabled by setting the control panel or by using
CentreWare IS.
Note
To determine the system’s IP address, select System Identification at the control panel.
For information about the control panel, see the Features section of this guide.
Changing or Modifying the IP Address Using CentreWare IS
CentreWare IS provides a simple interface that enables you to manage, configure, and monitor
networked systems from your desktop using an embedded web server. For complete
information about CentreWare IS, click the Help button in CentreWare IS to go to the
CentreWare IS Online Help.
After setting the system’s IP address, you can modify TCP/IP settings using CentreWare IS.
1. Launch your web browser.
2. Enter the system’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx).
3. Select Properties.
4. Select the Protocols folder on the left sidebar.
5. Select TCP/IP.
6. Enter or modify the settings, then click Save Changes at the bottom of the page.
Information Required for Manual IP Addressing
Information Comments
Internet Protocol (IP) address of the system Format is xxx.xxx.xxx.xxx, where xxx represents
a decimal number from 0–255.
Network Mask If you are unsure, leave this blank; the system
chooses an appropriate mask.
Default Router/Gateway address Router address is required to communicate with
the host device from anywhere other than the
local network segment.