Smart Technologies 800i5e-SMP - Manual (Page 97)

3. Configure your serial interface settings using the values from the table in the previous section,
and then press ENTER.
An “invalid cmd= ? for help” message appears, and the > character appears as a command
prompt on the following line.
N O T E
If no message or an error message appears, your serial interface configuration isn’t correct.
Repeat step 3.
4. Type commands to configure your settings.
N O T E S
o To see a list of commands available in the current operating mode, type ? and then
press ENTER.
o If you’re using a terminal emulation program, turn on your program’s local echo setting
to see characters as you type them.
Projector programming commands
This section documents the projector programming commands.
Projector power state controls
Your projector responds to commands only at certain power states and times.
There are five projector power states:
l
Powering (startup)
l
On (operating)
l
Cooling
l
Confirm off
l
Idle (Standby mode)
Command inventory
Your projector responds to the commands in the tables on the following pages. To see a list of valid
commands in the projector’s current power state, type ? and press ENTER.
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
85