Smart Technologies 800i5e-SMP - Manual (Page 108)

Command Command target range Response
set emergencyalertmsg
[description] Enter a descriptor no more
than 60 characters long. emergencyalertmsg=[description]
set emergencyalert [target] =on
=off
emergencyalert=[target]
These commands control the current system settings. These commands are available when the
projector is in Standby mode and when it is on.
Command Command target range Response
set restoredefaults [none] restoredefaults=done
set lamphrs [target] =0 lamphrs=0
set vgaoutnetenable [target] =on
=off
vgaoutnetenable=[target]
set usb1source [target] =vga1
=vga2
=hdmi
=disabled
usb1source=[target]
set usb2source [target] =vga1
=vga2
=hdmi
=disabled
usb1source=[target]
N O T E
The Network and VGA Out setting’s features are off by default. Select on to activate these
features.
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
96