Smart Technologies 800i5e-SMP - Manual (Page 41)

Setting Use Notes
Native DLP
Resolution Selects 16:10 or 16:9. The default is 16:10, which is the
correct setting for SMART Board 885
interactive whiteboards.
This option is only available on
SMART UF75w projectors with DDP
fimrware version 0.0.2.1 or later.
When you select 16:10, the projector’s
native resolution is 1280 × 800.
When you select 16:9, the projector’s
native resolution is 1280 × 720.
Network menu
Network and VGA
Out Activates the projector’s VGA Out and
RJ45 connector and network features.
Status Displays the current network status
(Connected, Disconnected or Off). The default is off.
DHCP Displays the status of the network’s
Dynamic Host Configuration Protocol
(DHCP) as On or Off. The default is on.
On enables a DHCP server on the
network to automatically assign an IP
address to the projector.
Off enables an administrator to assign
an IP address manually.
Password
Reminder E-mails the network password to the
predefined e-mail recipient. See Web page management on page
73 to set up a destination e-mail
address.
IP Address Displays the projector’s current IP
address in values between 0.0.0.0 and
255.255.255.255. To change the projector’s IP address,
use the RS-232 connector (see
Network controls on page 92) or use a
DHCP server to assign a dynamic IP
address, and then set a static IP
address using the network remote
management feature (see Remotely
managing your system through a
network interface on page 73).
Subnet Mask Displays the projector’s subnet mask
number in values between 0.0.0.0 and
255.255.255.255.
Gateway Displays the projector’s default
network gateway in values between
0.0.0.0 and 255.255.255.255.
DNS Displays the projector’s primary
domain name number in values
between 0.0.0.0 and 255.255.255.255.
C H A P T E R 4
Using your interactive whiteboard system
29