Smart Technologies 800i5e-SMP - Manual (Page 98)

I M P O R T A N T
When entering commands, ensure there is a 10 millisecond delay between characters for reliable
operation.
N O T E S
l
Send a command only after the projector sends a command prompt.
l
Commands aren’t case sensitive. Type commands exactly as they appear in the left column
of the tables, with the proper value or setting in the center column.
l
Check your entries carefully before entering your commands.
l
Press ENTER after typing each command.
l
After the projector executes a command, it generates a response.
l
To prevent buffer overrun, don’t send another command until you receive the next command
prompt.
Value-based command methods
Absolute values and adjustment values
You can use the command’s target range to set an absolute value for a command or cause an
adjustment to be made to the current value. To create an adjustment command, add a plus (+) or
minus (-) symbol instead of the equal symbol (=) before the value change you want to enter.
All absolute values you enter must be within the command target range, and all adjustment values
must equal a number within the command target range.
See the following examples for adjusting projector brightness:
>get brightness
brightness=55
>set brightness=65
brightness=65
>set brightness+5
brightness=70
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
86