ATEN ATEN MasterView CS-1764 - Manual (Page 21)

11
Chapter 3.
Basic Operation
Manual Switching
There are two convenient methods to access the computers: Manual - which
involves pressing the push button port selection switches located on the unit’s
front panel; and Hotkey - which involves entering combinations from the
keyboard. Hotkey port selection is discussed in the next chapter.
For manual port selection:
Š Press and release a port selection switch to bring the KVM focus to the
computer attached to its corresponding port. The USB and Audio focus
does not change - they stay with the port that they are already on.
Š Press and hold a port selection switch for more than 2 seconds to bring the
KVM focus, plus the USB and Audio focus to the computer attached to its
corresponding port.
Š Press and hold port selection switches 1 and 2 for more than 2 seconds to
start Auto Scan Mode, see page 16 for details.
Š Press and release either port selection switch to stop Auto Scan Mode. The
KVM focus goes to the computer attached to the corresponding port of the
switch you pressed.
Hot Plugging
The Master View CS-1762 / CS-1764 supports USB hot plugging -
components can be removed and added back into the installation by
unplugging their cables from the USB hub ports without the need to shut the
unit down.
cs1762.book Page 11 Friday, February 17, 2006 10:21 AM