AEG L61271WDBI - Manual (Page 5)

WARNING!
Do not look directly into the
beam of the lamp.
To replace the internal lamp,
contact the service centre.
Disconnect the mains plug from
the mains socket before the re-
placement of the internal lamp.
INSTALLATION
• The appliance is heavy, be careful
when you move it.
• Do not transport your appliance with-
out the transit bolts, you can damage
internal components and cause leak-
ages or malfunctions.
• Do not install and connect a dam-
aged appliance.
• Make sure to remove all packaging
and transport bolts.
• Make sure that the mains plug is dis-
connected from the mains socket
during installation.
• Only a qualified person must do the
electrical installation, the plumbing
and the installation of the appliance.
This to prevent the risks of structural
damage or injury.
• Do not install or use the appliance
where the temperature is less than 0
°C.
• When you install the appliance on a
carpet floor, make sure that there is
air circulation between the appliance
and the carpet. Adjust the feet to
have the necessary space between
the appliance and the carpet.
Water connection
• Do not connect the appliance with
old hoses already used. Only use new
hoses.
• Make sure not to cause damage to
the water hoses.
• Do not connect the appliance to new
pipes or pipes not used for a long
time. Let the water flow for some mi-
nutes, then connect the inlet hose.
• The first time you use the appliance,
make sure that the water hoses and
the couplings do not have leakages.
Electrical connection
• Make sure that the appliance is
earthed.
• Make sure that the electrical informa-
tion on the rating plate agrees with
the power supply.
• Always use a correctly installed
shockproof socket.
• Do not use multiple plugs and exten-
sion cables. There is a risk of fire.
• Do not replace or change the mains
cable. Contact the service centre.
• Make sure not to cause damage to
the mains plug and cable.
• Connect the mains plug to the mains
socket only at the end of the installa-
tion. Make sure that there is access
to the mains plug after the installa-
tion.
• Do not pull the mains cable to dis-
connect the appliance. Always pull
the mains plug.
• Only for UK and Ireland. The appli-
ance has a 13 amp mains plug. If it is
necessary to change the fuse in the
mains plug, use a 13 amp ASTA (BS
1362) fuse.
• Permanent connection. To connect
the appliance permanently, install a
double-pole isolating switch between
the appliance and the electricity sup-
ply. It must have a minimum distance
of 3 mm between the switch contacts
and it must be the correct type for
the necessary load. It must agree
with the last electrical legislation. The
switch must not break the yellow and
green ground cable.
Only a qualified electrician must in-
stall this type of device.
DISCARD THE APPLIANCE
1. Disconnect the mains plug from the
mains socket.
2. Cut off the mains cable and discard
it.
ENGLISH 5