Agri-Fab Mow-N-Vac 45-04072 - Manual (Page 11)

11
2. Slide two of the lower support rods through the center
loops located in the top of the cart cover as shown in
figure 20.
3. Slide the last lower support rod through outer edge of
the cart cover. The bend in the rod must face in the
direction shown in figure 21.
CENTER LOOP
SUPPORT
RODS
CENTER LOOP
CART COVER
FIGURE 20
BEND
CART COVER
SUPPORT ROD
SPRAY
ADHESIVE
FOLD EDGES
TOP SUPPORT
ANGLE
CART
BAG
FIGURE 21
FIGURE 22
4. Apply spray adhesive to the side of the top support angle
shown in grey. Follow directions on spray adhesive for
proper application. See figure 22.
5. Once the spray adhesive is tacky to touch, place top
support angle inside of cart cover and fold the edges of
the cover onto side of support angle with spray adhesive.
See figure 22.
6. Wait until adhesive dries, securing support angle in
place, before continuing to step 7.
PERFORM STEPS 4-6 IF YOU ARE USING SPRAY
ADHESIVE (RECOMMENDED). IF YOU ARE NOT USING
SPRAY ADHESIVE, SKIP TO STEP 7 ON PAGE 12.
ASSEMBLING CART COVER
1. Slide the front support tube through the double loops
located near the front of the cart cover. See figure 19.
DOUBLE LOOPS
FRONT
SUPPORT
TUBE
CART COVER
FIGURE 19